Alpha GX Wave Bidet Seat GX-Wave-E-W

Product Details:

With its attached side control panel, low profile design, 3 wash modes and strong drying performance, the Alpha GX Wave is the perfect no-frills bidet seat that’s focused on results. At its core, the GX Wave is powered by a hybrid heating system that offers 3 wash modes: Rear, Rear+, and Front Feminine. Its warm water supply is not endless, but the spray never turns completely cold either thanks to continuous heating. The Rear+ cleansing mode is a highlight of the GX Wave and is capable of spraying just over 1L per minute of warm water. The spray is strong and the generous water volume provides an extremely effective rear cleansing experience on par with seats that cost three times as much. Performance focused, value driven. 

• Hybrid heating system
• White LED nightlight
• Stainless steel nozzle
• Sturdy, Sittable Lid
• Side panel control
• Rear and rear+ wash
  
• Front feminine wash
• Adjustable spray pressure and temp
  
• Adjustable nozzle position
• Adjustable nozzle w/ oscillation and pulse modes
• Warm air dryer w/ adjustable temp
• Heated seat w/ adjustable temp
• Adjustable Water Temperature
• Slow close seat and lid
  
• Power saving economy modes
• 1 year warranty

Specifications:

Toilet Fitment Guide:

Is your toilet compatible with an Alpha Bidet?

1 PIECE VS 2 PIECE

• 2 piece toilets are the most common residential style toilet. If you have one, great, our Alpha Bidets will fit.

• 1 piece toilets have the tank and bowl molded into a seamless unit. If you have one, you'll want to check the "Special Cases" section below.

MEASURING YOUR BOWL

• A: The JX and ONE models require a minimum of 1.5" of clearance. The iX Hybrid and GX Wave need 1.75"

• B: 5.5" is the standard, which the JX requires. The ONE, iX Hybrid, and GX/GXR Wave will accept a range of 5"-7"

• C: Most elongated bowls measure 18.5" from the bolts. Most rounds measure about 16.5"

Installation Guide:

Alpha JX , iX Hybrid, GX/GXR Wave

• 1) To install, first remove your existing toilet seat and lid. Turn the water supply valve off and flush the toilet tank completely.
• 2) Disconnect the supply hose from the toilet tank and install the 7/8″ t-valve. Then, reconnect the water supply hose to the bottom of the t-valve.
• 3) It comes with a mounting plate and two mounting bolts. Place the bracket over the bolt holes and insert the mounting bolts.
  The mounting plate can be adjusted back and forth for better alignment with your toilet. Tighten the bolts from the underside of the bowl using the plastic nuts. If top mounting bolts are provided, insert the rubber sleeves into the mounting holes first, then tighten the metal screws.
• 4) Lock the bidet seat into place by sliding the unit back into its mounting plate. There should be an audible click when the seat is locked.
• 5) Next, connect the optional water filter and the bidet hose to t-valve. Connect the other side of the hose to the bidet seat.
• 6) Once the plumbing is connected, open the shutoff valve at the wall and check for leaks. Finally, plug the electrical cord into a GFCI outlet.

WARNING: This product can expose you to chemicals including Lead which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov